Motion Control
I have two B7R servo drives on a B&R PLC. There are 4 servo motors connected. But, when i check SDM, there are 6 servos. Why is it showing 6 servos? Is it possible to delete unused servos?
top of page
To see this working, head to your live site.
General Discussion
Anything that does not fall under the listed categories.
3Electrial Design
Wiring, Cables, Transformer, Protection, Breakers, Meters and more
1PLC & Industrial Controllers
Allen Bradley, Siemens, B&R, ABB, Mitsubishi, Omron, Delta, Honeywell, GeFanuc, Schnieder Electric and more
4Industrial Robots
Fanuc, KUKA, Yaskawa, ABB and more
6HMI & Displays
Allen Bradley, Siemens, Honeywell, ABB, Schneider Electric and more
4Industrial Cameras
Keyence, Cognex, Apera AI, Baumer and more
5Networking & Communication
EtherNet/IP, DeviceNET, CAN bus, Modbus, IO-Link and more
2Scriber & Marking Systems
Technifor, Telesis, SIC-Marking and more
4Motion Control
Servo Drive, VFD, Stepper Drive and more
1
New Posts
- PLC & Industrial ControllersDoe anybody know how to interconnect A1 and A2 ports on AB PLC? The ports are on different IP connected to separate switches. There is no physical connection between the switches. I want to access devices on A2 port through A1 port.
- Industrial CamerasI have a brand new VS camera. When I try to access it from VS creator, it is asking for firmware update. I tried multiple times, but it is failing. Need help.
bottom of page